Gleason No. 506 Hypoid Lapping Machine


Gleason No. 506 Hypoid Lapping Machine

Stock Number: gh951

Serial No. 759107      Age: 1978


                                                       



SpecificationDescription
Gear outisde dia. max.20" 508mm
Pinion outside dia. max.10" 254mm
Offset of pinoin spindle center in either direction 
from center of gear spindle (max.)3" 76.2mm
Gear spindle nose to gear axis (min.)4-1/2" 114.3mm
Gear spindle nose to gear axis (max.)7-1/2" 190.5mm
Pinion spindle nose to gear axis (min.)6-1/2" 165.1mm
Pinion spindle nose to gear axis (max.)12" 304.8mm
Pinion shank length (from backing): Standard3-4/5" x 3"
Brake load: Standard20-200 in. lbs
Brake load: Optional300 in. lbs
PINION SPINDLES Standard Large Bore 
Dia. of taper hole at large end3-29/32" 6"
Taper per foot39/64" 3/4"
Depth of taper3" 2-1/2"
GEAR SPINDLES 
Dia. of taper hole at large end2-19/64" 3-29/32"
Taper per foot1/2" 39/64"
Depth of taper3"
PINION SPINDLE SPEED RANGE 
Standard1800 & 1500 RPM
Optional1200 & 900 RPM
ELECTRICAL EQUIPMENT 60 CYCLE3 Phase, 460 Volt
Main motor5 HP 1680 RPM
Hydraulic motor5 HP 1800 RPM
Compound mixer1/2HP 1800 RPM
Floor Area86" x 93" x 72"
Electrical Panel18" x 80" x 72"
Net weight15,000 lbs

Equipped With:
The gear and pinion are automatically chucked and de-chuck. The gear and pinion are automatically meshed. Pre-selected amount of backlash is automatically introduced. High speed lapping controls. Four dial settings - 2 for the drive side, 2 for the coast side. Slurry pump and tank.


HomeIndexContactView Cart


Gleason No. 506 Hypoid Lapping Machine
adams@adamsmachinery.com



Asset Sales and Marketing Software for Used and Surplus Industrial Machinery and Equipment Dealers
www.MacDB2000.com