No. 6 Gleason Combination Hand Rolling & Power Angular Hypoid Bevel Gear Tester


No. 6 Gleason Combination Hand Rolling & Power Angular Hypoid Bevel Gear Tester

Stock Number: gh988

Serial No. 18219


                                         
Click to view larger photo


SpecificationDescription
Maximum Diameter Of Gears7.5"/(190.5mm)
Range Of Angles0 To 180 Degrees
Range Of Pinion Offset: (Above Center)1-1/4"/(31.49mm)
Range Of Pinion Offset: (Below Center)1-1/4"/(31.49mm)
Max./Min. Distance Pinion Spindle Center To Nose Of Gear Spindle7"/0" (177.8/0mm)
Max./Min. Distance Gear Spindle Center To Nose Of Pinion Spindle7"/1" (177.8/25.4mm)
Diameter Of Spindle Hole (Large End)1-51/64" (45.64mm)
Taper Of Spindle Per Ft.1/2"/(12.7mm)
Depth Of Taper3"/(76.2mm)
Diameter Of Thru Hole1-5/16" (33.337mm)
Floor Space Required37" X 42" (940x1067mm)
Machine Net Weight1,900 Lbs. (863.6 Kgs)

Equipped With:
Standard Two-Speed, 2-HP/1-HP 440 Volt, 3-Phase, 50/60 Cycle, 1800/3600 RPM Drive Motor W/Pulleys & Belts. Two-Speed Drum Switch. Forward/Reverse Spindle Rotation. Manual Braking System For Load Simulation. Spring Chucking Mechanism (Both Spindles). Standard Bore Spindle 1-51/64" Diameter. Full Complement Of Electrics (Motors/Controls). Gleason Test Standards.


HomeIndexContactView Cart


No. 6 Gleason Combination Hand Rolling & Power Angular Hypoid Bevel Gear Tester
adams@adamsmachinery.com



Asset Sales and Marketing Software for Used and Surplus Industrial Machinery and Equipment Dealers
www.MacDB2000.com